MAIN PAGE » KTM » KTM 1290 » 1290 GT 2016 + » Clutch cover transparent for LC8 KTM engine in black by EVOTECH Italy
.jpg "Clutch guard and pressure plate LC8 KTM engine - Black / Orange - EVOTECH S.R.L")
.jpg "Preview: Clutch guard and pressure plate LC8 KTM engine - Black / Orange - EVOTECH S.R.L")
.jpg "Clutch guard and pressure plate LC8 KTM engine - Black / Orange - EVOTECH S.R.L")
THE ORIGINAL
Clutch cover for LC8 KTM engine - Black by EVOTECH Italy
Scope of delivery:
Black clutch cover - without the clutch release. This must be ordered separately.
Only suitable for the LC8 KTM engine (1290 R, 1390 R, GT, Adventure).
CNC machined from billet aluminium in Italy.
The set is equipped with 5 longer screws made of galvanised steel. Coloured aluminium screws are available as an alternative.
The sealing ring from the installed clutch cover can be used (not included in the delivery, but also available).
Tightening torques: 12 Nm for the clutch release, 10 NM for the clutch cover.
The Plexiglas cover is ready mounted.
An initial milky cloudiness of the Plexiglas due to condensation is normal. This disappears after the first warm-up.
There is a video here on YouTube
Clutch cover for LC8 KTM engine - Black by EVOTECH Italy
Scope of delivery:
Black clutch cover - without the clutch release. This must be ordered separately.
Only suitable for the LC8 KTM engine (1290 R, 1390 R, GT, Adventure).
CNC machined from billet aluminium in Italy.
The set is equipped with 5 longer screws made of galvanised steel. Coloured aluminium screws are available as an alternative.
The sealing ring from the installed clutch cover can be used (not included in the delivery, but also available).
Tightening torques: 12 Nm for the clutch release, 10 NM for the clutch cover.
The Plexiglas cover is ready mounted.
An initial milky cloudiness of the Plexiglas due to condensation is normal. This disappears after the first warm-up.
There is a video here on YouTube
- Manufacturer:
SEVENTYONE S.R.L.
Zona Industriale Palù, 6G - 38055 Grigno (TN)
Phone: +39 0461 780184
info@evotech-rc.it
General safety instructions for the product:
We recommend that you always consult a specialist workshop when fitting our products or have this work carried out by a specialist. If you fit it yourself, please make sure that your motorbike is secure and that the product is only intended for your motorbike. The models for which the product is tested and intended can be found with each item.
To avoid damage to your motorbike during installation, we recommend covering all important/sensitive parts. Please understand that we cannot accept any liability for consequential damage caused by improper installation.
When fitting, use threadlocker if possible and observe the torque specifications. The fixing screws on the licence plate holder in particular should be secured with threadlocker. Loss of the licence plate holder due to lost screws can cause unpleasant damage.
General torque specifications can be found HERE
The legally required licence plate angle of 30 degrees can be set on the Italian licence plate holders
Information for our Austrian customers specifically for the type approval and registration of licence plate holders can be found HERE
Unfortunately there are no reviews yet. Be the first who rates this product.
You must be logged in to submit a review. Login
Customers who bought this product bought also the following products:
This product was added to our catalog on Sunday, February 18, 2018.